New evaporator Maze GT1 by tiborrr

[tiborrr]

After months of no spare time to spend on the Mach restoration, the unit is now finally done:



Sloppy me - burned through copper pipe due to thermal load of acetlyene/O2 torch flame:


Brazed evap Maze GT1:


System running while charging. The manifold is a bit f$$ked up, so the low side port is attached to high side manifold's port:


-62°C but unstable, -72°C was achieved for a second or two before the compressor shut down


The unit is faily overcharged, but the pull down is mega fast - about 20-25 seconds from +20°C to -40°C, perhaps due to evaporators really low mass. The report on the temperatures will probably be tommorrow because i still have to find the optimal charge for it.