Hornet331: It does undervolt at any setting below that. I think there is a problem with voltage regulator overcorrecting at that point...not sure, maybe a bios bug though. Until Gigabyte releases a bios that doesnt default to 1333 on the memory though, I probably won't find out, or unless they do a non-beta release...my Vdimm is also jumpinng around a bit from 2.00 set in bios (+ .50) to 2.10. memory is slightly warm to the touch while priming, so I am not too concerned...
ToyTen: most recommendations I've seen for ddr3 usually have a 1T cr, until you start overclocking the ram...funny that OCZ doesnt list their subtimings at all, you may be able to ask in their forums for correct subtimings if you run into problems though...and of course if 1T is not stable for you, then 2T it is
ChrissTi: Any lower voltages and Prime locks up immediately, 1.65v is the most I can set it at, the settings start going by .05v after that (1.70,1.75, etc.)
Reply With Quote
Bookmarks