Thanks!
Appreciate all the comments and looking for suggestions as I progress. I looked a t single outlet only and I think it's possible but to do it right I think I need a sine vise or table to do some tapered ports. I could also cut a 1/4" channel all the way around, but I think you'd get too much flow favoring one side, so for now I went with the triple to start off...center inlet, dual outlet.
Got a good start on the top block after throwing away my first shot (barbs were too close).
Learning alot of little quicks here and there. Using WD40 for all cuts, tapping with the drill press really helps alot...etc.
Anyway...here are the top block pics and where I'm at now:
Underside:
Top down view:
Getting there..
Reply With Quote
Bookmarks