for all you doubters of Cryo-tek who said it wasn't possible to hold a high load @ low temps on an autocascade . If you're wondering what I'm talking about, check here - http://www.xtremesystems.org/forums/...ad.php?t=97265
BTW - I have absolutely NO IDEA what I'm doing on this Asus P5wd2E-Premium so please excuse the poor results of the benches.....at least until I figure out what all the settings on this mobo do.....

The CPU:



Initial Boot:



The Screenie - I hope it counts since I hadn't yet updated my CPUZ so my validation file isn't allowed



This is what matters though...an 8m @ a HIGHER SPEED than the previous WR. Vcore was actually drooping on the shot (I didn't bother adjusting my droop mod ). Running Vcore was around 1.70v. ~-100C Evap temps LOADED....not bad for a single compressor and a heater on the back of the mobo, eh? That makes this unit 2 for 2 -> 2 CPU's, 2 WR's Now to figure out how to get 1.9Vcore...



Special thx to FCG for loaning me this setup to test my unit (and of course to Cryo-tek for modding it)