Need Confirmation on BSEL pad mod for e4300

[bryan_d]

Hello all,

I bought my father the $150.00 Fry's P4800M/E4300 Combo, and was hoping to mod it to boot at a default of 1066FSB instead of the 800FSB.

I have been reading a bunch of pages on BSEL modding but I am still not 100% sure of what I should really do.

I grabbed some spec sheets from Intel and came up with a few diagrams to help answer my question:



Basically I need to know which pads I need to isolate or connect. To isolate I would use some electricle tape, and to connect I have both a defogger kit and a Conductive Ink Pen.

From what I read, I should just connect BSEL1 to BSEL2 to achieve the "Low" signal? Is this correct?

All help will be greatly appreciated,

Bryan d