1) In or Out of a chassis? (If in chassis, type of standoffs)

Out

2) 4 lights or 3 lights on when dead?
3

3) 5V or 3.3V Vmem jumper position?
3.3v

4) What was Vmem set to?
2.8v

5) What was Vcore base voltage set to?
1.45v

6) Were you using VID special? If so, what % setting?
110%

7) What was Vcore startup voltage set to?
1.45v

8) Type of memory used at the time? (TCCD, BH-5, UUT, etc.)
TCCD

9) FSB setting at the time?
250

10) Multiplier in use at the time?
9x

11) Processor type in use at the time (i.e. 3200+ Winnie or FX-55 or 3200+ NewCastle or Venice or ???)
3000+ CBBID Winnie

12) What was the last thing you did just before it croaked? (Changed VMem, Vcore, lost your lucky rabbits foot, ???)
Absolutely nothing. Froze at a game's menu screen. On settings that are stable for gaming. Seems it will never boot again either.

13) Did you notice if the Vmem good LED was lit (between DIMM slot 2 and 4-pin 12V cnx)
Yes, lit

14) Air, water, or phase-change on the CPU?
Air

15) MB jumper position settings (any you remember)
Basic stuff. 1x6800GT so those jumpers are default. Debug speaker on.... that's really it. Everything default.


16) What else was hooked into your system (PS2 mouse, USB this, PCI that, Gfx card)
Wireless network card, Audigy 2Zs, BFG 6800GT OC

17) Power supply make/model being used?
OCZ PowerStream 600w

18) Did you notice if the Standby Power LED was lit after it died (just to the right of the diagnostic LEDs)
Yes, on.

19) Did you have all of the MB power connectors hooked up?
I didn't thinnk I would need all that crap for 1 graphics card.