Xtreme Twinmos Memory!

[uwackme]

With no sig's I have no idea what you are running them on or at what settings...complete settings.

If they are normal un-redesigned BH5 then they will act like BH5. So in NForce2 boards they will suk azz.

Chester did you get 1A4T "new BH5" sticks? 2x512M? Ill trade you my 1G CH5 that does 235Mhz 11,2,2,2.0 2T for them?

[Formann]

With no sig's I have no idea what you are running them on or at what settings...complete settings.

If they are normal un-redesigned BH5 then they will act like BH5. So in NForce2 boards they will suk azz.

Chester did you get 1A4T "new BH5" sticks? 2x512M? Ill trade you my 1G CH5 that does 235Mhz 11,2,2,2.0 2T for them?

Sorry about that.

Im running them on a 3500+ CAAZC good for 280 tight with my old pair of BH5 or 300+ with TCCD. MOBO is a DFI nF4.

[[timko]]

With no sig's I have no idea what you are running them on or at what settings...complete settings.

Ok, here's my setup BEFORE I put in the Twinmos...

NF7-s v2.0 with NO wire mods of any kind.
Manta Rays D26 XT CPC On (1T)
XP-m 2500 IQYHA + SLK900a
2 x 512Mb Patriot XBLK (TCCD)@ 2.9v and 2-3-3-11

...and here's a pic of it running rock solid at 8mb SuperPi 238Mhz FSB (can also do 16Mb and 32Mb and also hundreds of rounds of memtest #5 error free but I didn't get a shot of those)...

http://img200.exs.cx/img200/5615/timko8mb7272io.jpg


When I switched out the TCCD and replaced it with the two sticks of Twinmos 1A4T BH-5, I set the timings to SPD as advertised -> 2.5-4-4-9, I set the FSB to stock for the RAM which is 216Mhz and put the vdimm to 2.9v... and these are the only settings I changed. This results in memtest #5 multiple errors

So as you can see, the rest of my rig can do a higher FSB with absolutely no issues with the TCCD RAM so why can't this BH-5 operate error free at a lower FSB?

RMA Time?