The Official OCZ VX Thread - Strictly Test Data Only!!!

[bachus_anonym]

so, just came back from work and this is what i got so far - not much but this is just first result i got:

256x10, DDR512 6-2-2-2.0 @ 3.50v REAL LOAD;OCZ DDR Booster

MSI K8N Neo2 Platinum - Q47353.1 0440A2 S Taiwan
A64 3200+ 90nm "Winchester" - CBBFD 0441UPCW
Thermalright XP-90 w/ YTech 120mm



CLICK for Full Size Screenshot - 2048x1536 281KB



CLICK for Full Size Screenshot - 2048x1536 343KB



CLICK for Full Size Screenshot - 2048x1536 326KB



after raising vcore just a bit i'm @ 260x10 and "priming" - 1hr so far

as far as "DIVIDER problem" then you can add another one to the list i cannot POST at above 279HTT, for sure not w multis x8, x8.5, x9, x9.5 and x10... and that's with memory divider 166 or even with 200 relaxing timmings, 1T or 2T - no help

i think there's something wrong with BIOS/VX config.... maybe some sort of incompatibility ??? just a thought.... with 2x256 BH-5 i can easly prime @ 325x8 with divider 166. although, i could not post above 313HTT with 2x256MB BH-5.... i had to POST with 313HTTx8 and then in jack up HTT in clocgen to 325HTT.... wired stuff... unfortunately this trick didn't work with VX i booted with 270x9 divider 166, then raised to 280HTT (can't normally post with that) and after that only CLEAR CMOS and Power OFF brought Neo2 to life....

i'll be working on it and let you know if i get something... if this won't get fixed then it BLOWS big time as i'm also preparing for some phase change action on that board