520w Powerstream 3.3 line problem.

[RocKer]

I have my 520w now for a week back from RMA,but when i wont to crank up the 3.3 line with the pot to 3.5v it dos not want go any further then 3.4v,3.43v,its at the end of the pot,i dont get it to 3.5v,dont think thats ok.

Can somebody from OCZ give some info on what to do.

[RocKer]

Hallo is there nobody from OCZ here,please respond.

[jinu117]

I suggest call them up and talk to them. Much faster that way.

[andyOCZ]

Sorry Rocker, this is not our main support forum and sometimes we miss a post.

If you are checking in your BIOS I wouldn't trust the PC Health readout or any monitoring in windows for that matter. the only way to tell for sure is to test with a volt meter.

With a digital multimeter check your +3.3v rail thru the 5pin AUX connector which is never used. Set your multimeter @ 10 or 20v DC and use the orange wire (+3.3v) and black wire (ground). This will be an accurate test.

Let me know. You can always PM me.

Thanks

[RocKer]

Thanks for the reply,i will check it out with a digital multimeter(i have one).

Is it better to post a Q in the BE forums in the future.