Help antec true control and MSI neo2 !!

[Perc]

well with my set up ive tried with and without the external bay thing installed and if you read your psu's manual you see that with the external bay unpluged the psu defualts to 95% of its rated output so the 3.3v rail is running lower then it would with the external bay pluged in and the 3.3v rail turned all the way down. but deff an interesting point you got there. just too bad in my case it didnt help me any... i will try your idea just incase but i dont hold my breath...

thx perc,

[FXFreaK]

The support guys over at OCZ had the same problem as you/I. The only thing that got the k8n neo2 to boot again was:

1. Shut off the PSU
2. Disconnect all power cables, all drives, everything...
3. Remove the BIOS battery
4. Shorten the two batterypins with something metal *duh*
5. Wait a couple of minutes
6. Reconnect everything and try.

This worked for me, I got the PowerStream to work with my k8n neo2 again. But it didn't last long, few days later my mobo was totally dead!!

I'm so f***ing mad at MSI not to go public with this problem! But the funniest thing was when I got my Abit AV8. They didn't even tell on their homepage that winchesters wouldn't work with BIOS older than version 1.5. Had to do a hotswap flash with my old NF7S V2. I'm starting to think that the socket 939 is all a joke! I've never ever in my whole life experienced a socket relase with so many problems.

//Over and out

[split]

Going to revive an old thread, but has anyone stuck their fingers on 'PH3 PB5350' when it fails?



See thread as his run @ 164ºC

[jinu117]

Going to revive an old thread, but has anyone stuck their fingers on 'PH3 PB5350' when it fails?

See thread as his run @ 164ºC

Just checked mine and it is @40c or so. Something is wrong with his system. What does that part do? Most of mosfets are "only" rated up to 120-130c.

[klootzakje]

my antec 480 truepower is also not working it doesn't do anything at all, not even a fan or led