This is my initial run so far and i can't figure out how to get more volts out of the 3.0 bios that i'm using. If you know chime in so i can put 1.7 to it and see what it'll do. I can post at 2.8ghz and get about halfway into windows then it bombs. With 1.7v maybe i could boot but who knows.
This is on air with an SLK948U and a 68cfm Panflow 92mm. I'm going to put it on my mod'd chilly1 promy here in this weekend. I'd love to get 3ghz on this puppy.
E8400 @ 4ghz 24/7
DFI LP LT X48-T2R
G.Skill F2-8500CL5D-4GBPK
BFG 9800GX2
2 x 150GB Raptor X in RAID 0
Hey guys! need help pls!
i have an Asus A8V and a 3200+ Winchester CPU. I have bought 2x Corsair 4400 Cl2,5 to let run CPU and RAM Synchronuos. But when i let run them synchronous , FSB 260/260Ram Windows Doesnt Boot or hangs up.Even with 250 it doesnt run stable... the only stable clock synchronous is 240
I have tried everything i think, i disabled the 2T Command, enabled it... but it runs not stable, i always get bluescreens and so on... what do i make wrong? ive set al Ram Timings manually already...vram.. i dont know more.
i have seen, that some people here have a K8N Neo running synchronous ram/FSB... why doesnt it run with my asus? is it a failure of the Via Chipset?
i can get a Epox 9NDA3+, thats with NF3, should i get it? somebody can tell anything about the epox?
When i set Ram to 200Mhz, my CPU does Stable 2,6Ghz@1,6vc... SuperPi 33sec.
the CPU is very good...
sorry for the bad english, im german
Posting Permissions
Reply With Quote
Bookmarks