Rig is broken down and being cleaned off using running hot water. should come out like a champ with its conformal coating.
zero issues last night with condensation, humidity was a little more than normal here in socal, but zero problems for an 8 hour pi session. just vaseline the dimms and let it rock. i did such a piss poor job at "insulating" with napkins lol. whatever works, they are just there to catch the drips as it defrosts.
...and it booted right up again before i started to clean it off this morning.
incase you are saying "thats alot of frost" there is alot of white napkin below that frost... but about an 1/4 inch thick piece of ice covering both the top and bottom corner of the motherboard to put it into perspective.
Allen, start clamping that block down. I have shots of -170 (where bbse coldbug) on dimms
Gotta look into this more, but my bbse was doing 6-9-6 @ 2600 last night right when i began overclocking, then after a few reboots and usual setup tweaks, it wouldn't do below c8 (avexir bbse not good air ones) thats when i switched to PSC. i have to figure out what i did that made it not drop cas anymore and never do it again.
Reply With Quote
Bookmarks