Finally, I'm just including some drawings of the design. I am going to try to keep it as close to this as possible. I modeled it to scale such that 1 unit of measure in the program is equal to 1 inch. That way I'll be able to keep to a spec a little bit easier. The chest will be produced later. Given that Saturdays are the only available day to work on this project, it will last for a little while. So, I'm figuring late may or early June for the chest.
I may do some work tomorrow. It depends on what I get done otherwise.
The chest design is meant to contain the unit such that it blends in with the room. I may paint the wood panels white; Just haven't decided. The top will likely be the most difficult piece to build given the shrouds that I will be making custom for ventilation. There will be one difference for sure, the 180mm radiators will pull air in with the fans likely on top. However, that isn't but a minor design change.
The base is missing the designed support channels. I forgot to unhide them when I rendered the image. They will run lengthwise on the base.
Reply With Quote
Bookmarks