I got some parts earlier..



A pair of fill ports. One will go up top, and the other as a drain valve somewhere, as due to the loop I'm planning, it will be a nightmare to drain without one.



These are Phobya Hex grilles. They're pretty nice and something a bit different.. However, they're almost too big for the fans. If you cut the whole so that all of the grille is open, you get a gap of about 2mm at the top and bottom before the fans start. This isn't a problem, just not ideal is all.



And one on the bottom as well. I'll have to re-cut the hole in the base, as even though no-one will see it, I'll know its there and it's not perfect.



A 120mm for the back too, just to keep the theme going. I'll need to trim the sides by about 2mm so that they don't over hand the side panel and the I/O ports hole.

All should be doable with the trusty jigsaw tomorrow in 20 mins or so.



In the mean time, the cardboard mock-ups continue. Never underestimate the power of the cardboard mock up.

More tomorrow..