GSKILL TridentX F3-2666C11D DDR3-2666 + ASUS M5G

[l0ud_sil3nc3]

I bet it's PSC. I don't think BBSE can do CL7 at 2133.

All BBSE should be able to do 2133 7-9-7-20 with 1.65v if they are not crap. Every set of BBSE IC based kit I have can run that and 2133 6-9-6-20 at 1.8v.

But ta's kit is most definitely a PSC based kit.

[trans am]

All BBSE should be able to do 2133 7-9-7-20 with 1.65v if they are not crap. Every set of BBSE IC based kit I have can run that and 2133 6-9-6-20 at 1.8v.

But ta's kit is most definitely a PSC based kit.

yeah its the 1st run of the pi blacks. which are better? for example I have a hyperx kit from the same hardware era and they couldn't do the timings and speed as the pi blacks. I think those are psc and the gskills are bbse.
or the hypers were something else altogether. they were just strange. were the 1st pi black kits bbse and then they switched to psc? Id love to rip them off and figure this out. Ive derailed this thread so badly now I just feel bad. sorry guys.

[theix]

All BBSE should be able to do 2133 7-9-7-20 with 1.65v if they are not crap. Every set of BBSE IC based kit I have can run that and 2133 6-9-6-20 at 1.8v.

But ta's kit is most definitely a PSC based kit.

I totally forgot about my previous owned 17000CL8D-4GBXMD. It's BBSE and it could do 2133/7-9-7-20 at 1.63v

The 16000CL9D-4GBRHD was also BBSE (some of them was EBSE) but the best it could do was 2200/9-9-9-27 at 1.65v. 2133/7-9-7-20 was no go.

[youngpro]

All BBSE should be able to do 2133 7-9-7-20 with 1.65v if they are not crap. Every set of BBSE IC based kit I have can run that and 2133 6-9-6-20 at 1.8v.

But ta's kit is most definitely a PSC based kit.

yeah your right and from testing so far BBSE might be able to do the cas5 easier than PSC, but a good kit of either will give you similar 32m results,

for my personal benching i will use a TridentX kit for everything except 32m and use PSC subzero for that..

[l0ud_sil3nc3]

yeah your right and from testing so far BBSE might be able to do the cas5 easier than PSC, but a good kit of either will give you similar 32m results,

for my personal benching i will use a TridentX kit for everything except 32m and use PSC subzero for that..

I would love one of those ultra bin covered in special sauce 2800 Trident kits but I think good PSC or BBSE under cold for 2D will be fine as you have stated.

However running 2800-3000 benchable is

and not mention one less variable to worry about especially if cpu and vga are cold.