Ultra low profile 1.35v 30nm DDR3 capable of 2400MHz. Perfect for SFF builds.

[LagunaX]

@Punisher! - no problems with cold boot with my board. Disconnected the power for 15 min and then plugged back in and booted up just fine. The earlier versions of Asus P67 boards did have a cold boot problem but was fixed by a B3 bios revision and/or "enable wakeup from PCI-E" in the bios. Also turned it on first thing in the morning (it's winter time) in a cold office this morning and was just fine too. Did my 1st hour Prime95 first thing this morning (cold boot) and the second 2 hr Prime95 right after the disconnect.

@Alex Ro - well tried 1.5v and 1.55v - both BSOD'ed around 45 min on Prime95 blend.

However...here is 2 hours Prime95 blend @ 1.6v vdimm @ 9-10-10-28 1T DDR3 2133 at the same 4.8ghz 4C8T
http://i246.photobucket.com/albums/g...msungLV16v.jpg


They just got a dollar cheaper @ the Egg and I guess these are keepers!