"V2" Koolance *Dual D-5* Bay Reservoir! (RP-452X2)

[Koolance]

man that is a drastic change, does 2.0 bleed better than 1.3 if you using it as two seprate res?

Maybe, the inlet/outlets are in the bottoms of both reservoirs (like RP-401X2). Some customers have had better luck with RP-401X2 versus RP-402X2 despite the smaller size.

Can we get some higher resolution pictures of the front of Rev 2.0? In particular how the baffles and the reservoir area?

They are the same design as our RP-401X2. Martin has some good shots of those. They're not exactly the same piece since the RP-452X2 Rev.2.0 are a little taller (because we have more room inside).

I like that Rev 2 much better, good change!

Thanks!

Will VL4N threaded males fit in P1 OUT and P2 IN without angled adapters?

Diameter-wise, yes. But VL4N is G 3/8 BSP threaded, and the RP-452X2 is G 1/4. You would need some thread adapters.

Koolance must have saved quite a bit on the material cost with this new revision, too.Phil

This version is still cut from a larger piece of acetal. Now there's also the extra stainless plates on the bottom, and we're including the serial 180-degree pipe kit with Rev.2.0.

Tim