Just a update on those who are on the sidelines waiting to purchase a Aquaero (XT | Pro | LT)... I purchased mine recently, well I purchased it a about two months ago but it took a while for AC to have everything I ordered in stock (mainly the AquagraFX blocks), I have have had it up and running for a few weeks now... any-hoot...

I did not have to do the jumper reset, I just plugged in the XT only and installed the Aquasuite 2012, did a firmware update... successfully...

downloaded the "aquasuite_setup_4.72.00" and named the channels on all my Power Adjust 2 to 50, 51 > 55 respectively, 1 per PA2 and each channel must be unique or Aquaero 5 will not recognize all of the attached PA2, this requires each PA2 to be connected to the USB port on the MB individually.. This step is only valid for those who purchased more than one PA2...

Plugged everything in and ran the Aquasuite 2012 Beta 9 and set everything up.. I had it up and running in about a hour or so...

Just a screenshot of the overview page, this thing is "butter"... !!!