NEW: aquaero 5 series

[gmat]

Well no luck with Aquasuite 2012. I have Logitech mouse & keyboard, run the "dimr" tool to confirm polling rate is 125Hz, so no problem here.

If i load up the old Aquasuite 4.72 and i plug my Poweradjust 2 on USB, it's working perfectly. I can see the flow monitor properly (which my AE5 cannot, on firmware 1010 - i have one flow sensor plugged on my PA2) and fan rpm monitoring is correct. My PA2 is on firmware 1003 so i uninstalled AS 4.72 and moved on to AS 2012 beta 9. Unplugged the PA2 from USB, plugged the AE5....

Then i launch AS 2012. It sees my AE5, good. If i go to "system" page my AE5 pro shows as "aquaero 5 lt" which it is not, it's a pro version (with the LCD). Firmware is 1010, if i try to flash it holds and doesnt even start flashing at all. Nothing happen on the device either.
Now what do i have to do ?

[aReado]

try this .....

1.) Turn off the PC and remove the standby power if you are using it.

2.) Remove all sensors from the aquaero.

3.) Place four jumpers on the temperature sensor connectors 5 to 8.

4.) Power on the system and after a few seconds you should see a recovery mode screen in the aquaero display.

6.) Turn the PC off and remove the jumpers from the aquaero.

7.) Start the PC and use the latest aquasuite 2012 software to flash the firmware onto the aquaero. It should perform a restart afterwards so you should see the regular screens now.

8.) Turn off the PC, connect all sensors etc. again and start the PC.
- from shogy

i do flash succesfully...

Well no luck with Aquasuite 2012. I have Logitech mouse & keyboard, run the "dimr" tool to confirm polling rate is 125Hz, so no problem here.

If i load up the old Aquasuite 4.72 and i plug my Poweradjust 2 on USB, it's working perfectly. I can see the flow monitor properly (which my AE5 cannot, on firmware 1010 - i have one flow sensor plugged on my PA2) and fan rpm monitoring is correct. My PA2 is on firmware 1003 so i uninstalled AS 4.72 and moved on to AS 2012 beta 9. Unplugged the PA2 from USB, plugged the AE5....

Then i launch AS 2012. It sees my AE5, good. If i go to "system" page my AE5 pro shows as "aquaero 5 lt" which it is not, it's a pro version (with the LCD). Firmware is 1010, if i try to flash it holds and doesnt even start flashing at all. Nothing happen on the device either.
Now what do i have to do ?