Right been looking into some of your requests.

Cannot say about the fin count as that's some thing were keeping close to our chest.

We will be doing M4 screws with 24 Long M4's and 24 Short M4's for the Triple and 16 Long M4's and 16 Short M4's for the double rad. This will save you messing around looking for the correct screw sizes and will allso give you enough to do push / pull, push / push, pull / push, pull or push.

We are all so looking to have 4 Ports. (2 in, 2 out)

Bleed valve.

Stamped logo on the side (small and discrete)

Full built in shroud.

We need to look at costing but i dont think it is out of our range.