Asus BD FX Support for Crosshair IV/890 boards

[wez]

does the setup still fire on?

Yea, still runs fine Testing 4600mhz as we speak at ~1.36v, 80w less drawn from the wall compared to 4750/1.45v

Ouch! That usually happens when contact is not firm enough. Perhaps the pins in the 8 pin connector were a tiny bit too wide/loose? Priming at 4750 sounds good though! Low VID is high powerdraw and loads of heat output. What temps did you see?

Connector was plugged in all the way, and now its stuck there extra good lol.
Temps where 60+, didn't pay too much attention to it