Hello Guys!

Today I have not had time to do all that much, but it was anyway something when you still were tool-home ...

I felt I had to do something about the fans... not because the cable is ugly ... whis they are not...but to make it flow with the rest of the theme









After those two fans I had a closer lookt at the start button ...I may fix me a 1.8mm LED tomorrow and then i will sleeve those cables aswell.



While I am passing by to the shop tomorrow I'm also going to fix the cable hole on the PSU bracket and the reservoirholders aswell...I have to buy some ulist too to make the cablehole look tidy!







I was for some reason somebody idea and I was looking where we had left the drill, once I had found it and began to remove some rivets, it looked like this ...





What I wanted with this was to create a backinlet, clean but nice ... Sure do, now I just need to fix more holes

Measured if it is possible to get there two pieces of 80mm fans ... and it worked!



Looks damn clean! ;D







When I got tired in my head, I sat around with BP stuff and played how it all would sit ... came to the conclusion that I must have a mini-extender or the pump will not be able to fit!

Q-Blocks are great to have the temp sensor input, etc. will fix so that the fillport and the tempsensor will sit on the Qblock while it goes to the res, should work this way





Here's how it looks almost the entire package out ... no pump and miniextender course ...





this was it for this late night!