Sandybridge for overclocking, two solutions review.

[Eldonko]

I have the exact same issue with mine. No stability if I tighten past 9-9-9 but on other boards 7-9-7 is fine. Plus it needs more voltage for 5Ghz and it overvolts quite a bit when you measure with DMM. EVGA said they wre working on the overvolting in the next BIOS release. Dont know about mem compatibility tough..

Explained in detail in my review under oc section - http://www.hardwarecanucks.com/forum...review-12.html

I just started playing with it last night to this morning... holy moley is the memory scaling/overclocking terrible!!!

I have a set that does 7-9-7@1.65v super pi 32m stable on my other motherboards, and this is the absolute best i could muster on the p67 ftw (took hours)

vdim,@1.65v
vccio@1.165v

The vcore is very bad also.. in os it shows 1.45 idle and 1.47 load but with my dmm it shows .06 higher at some points.

Is evga going to fix this or should i just sell it and buy a MIVE?