why is one CPU fan header is a 4-pin one and the other is a 3-pin one?
doesn't that make the auto fan control a problem?

check out the following graphs. see that there is a big difference when i set fan speed to level 2. no problem at full speed, as the board is not controlling the fan speed. maybe i should get a splitter and connect the two fans to one header?

i have two Coolermaster Blademaster fans in push-pull on my new Antec Kuhler 620. (yep, I bought a new cooler. XD)

#ambient is 31.2C, i don't know if it is right or not. but it is so damn hot.

idle

idle.jpg

getting past the 65C limit of the fan controller

midway.jpg

Prime95 blend after few minutes

fullspeed.jpg

i'll check if this is the same in UEFI too. i guess it would be.