So disappointed.4.8GHz passed 11 loops linx and crashed.
So close, but no cigar.
Here's my settings, any suggestions? I know my vcore is high. In fact I was a little scared about it. Of course this is not 24/7, can I go any higher on the vcore for a bench to see if I can get this 4.8 or anything else to try.
Code:Target CPU Frequency 4800MHz Target DRAM Frequency 1539MHz LN2 Mode [Disabled]*** QPI Loadline Calibration [Enabled]*** Sync Mode [] AI Overclock Tuner [Manual] OC From CPU level Up [Auto] 2D Performance Booster [Disabled] CPU Ratio Setting [23.0] CPU Turbo Power Limit [Disabled] >CPU Configuration---------------------------- CPU Ratio Setting [25.0] C1E Support [Disabled] Hardware Prefetcher [Enabled] Adjacent Cache Line Prefetch [Enabled] MPS and ACPI MADT ordering [Modern ordering] Intel(R) Virtualization Tech [Enabled] CPU TM Function [Disabled] Execute Disable Bit [Enabled] Intel(R) HT Technology [Disabled] *Active Processor Cores [All] A20M [Disabled] *Intel(R) SpeedStep(TM) Tech [Disabled] Intel(R) C-STATE Tech [Disabled] C State package limit setting [] C1 Auto Demotion [] C3 Auto Demotion [] ---------------------------------------------- BCLK Frequency [192] PCIE Frequency [105] DRAM Frequency [DDR3-1539MHz] UCLK Frequency [2887MHz] QPI Link Data Rate [Auto] Memory Configuration Protect [Disabled] >DRAM Timing Control-------------------------- CAS# Latency [ 8 DRAM Clock] RAS# to CAS# Delay [ 8 DRAM Clock] RAS# PRE Time [ 8 DRAM Clock] RAS# ACT Time [24 DRAM Clock] RAS# to RAS# Delay [Auto] REF Cycle Time [Auto] WRITE Recovery Time [Auto] READ to PRE Time [Auto] FOUR ACT WIN Time [Auto] Back-To-BackCAS# Delay [Auto] Timing Mode [1N] Round Trip Latency on CHA [Auto] Round Trip Latency on CHB [Auto] Round Trip Latency on CHC [Auto] WRITE To READ Delay(DD) [Auto] WRITE To READ Delay(DR) [Auto] WRITE To READ Delay(SR) [Auto] READ To WRITE Delay(DD) [Auto] READ To WRITE Delay(DR) [Auto] READ To WRITE Delay(SR) [Auto] READ To READ Delay(DD) [Auto] READ To READ Delay(DR) [Auto] READ To READ Delay(SR) [Auto] WRITE To WRITE Delay(DD) [Auto] WRITE To WRITE Delay(DR) [Auto] WRITE To WRITE Delay(SR) [Auto] ---------------------------------------------- CPU Differential Amplitude [Auto] CPU Clock Skew [Auto] IOH Clock Skew [Auto] ------------ Extreme Engine Digi+ ------------ Digi+ PWR Mode [X-Power] PWM Volt. Control [Auto] Load-Line Calibration [Full Calibration] CPU Voltage OCP [Enabled] CPU PWM Frequency [Auto] Extreme OV [Disabled] Extreme OC [Auto] CPU Voltage [1.60000] CPU PLL Voltage [1.6032] QPI/DRAM Core Voltage [1.3625] DRAM Bus Voltage [Auto] >DRAM REF Voltages---------------------------- DRAM DATA REF Voltage on CHA [Auto] DRAM CTRL REF Voltage on CHA [Auto] DRAM DATA REF Voltage on CHB [Auto] DRAM CTRL REF Voltage on CHB [Auto] DRAM DATA REF Voltage on CHC [Auto] DRAM CTRL REF Voltage on CHC [Auto] ---------------------------------------------- IOH Voltage [1.2] IOH PCIE Voltage [Auto] ICH Voltage [Auto] ICH PCIE Voltage [Auto] ---------- Spread Spectrum Control ----------- CPU Spread Spectrum [Disabled] PCIE Spread Spectrum [Disabled] ***on-board jumper dependant
Reply With Quote
Bookmarks