Gigabyte GA-P67A-UD5 Discussion Thread

[Falkentyne]

Is it the board itself that's warped or bad soldering of the I/O panel?
(like, it looks like the bottom left side of the panel is higher than the right side)

Because I know there is a screwhole JUST below that PS/2 port. And if that screw hole is completely down, the port should be flush (even with a warped board), since it's right above the screwhole. You can't have a warp there...it would have to be the panel itself is too high or warped), otherwise you would have difficulties just getting the screw flush with the screwhole.

Do you see what I mean?I'd love to see a pic of that board outside the case...I'm at my brain's limits....UNLESS the warp exists in the half inch between the screwhole and the edge of the board?

So I'm guessing the screwhole isn't even flush on that side...