[Project]: SR-2 Build (No name yet)

[JTF195]

So I've had this one done for a while:




But I hit another few snags. Once again, I seem to have misplaced a small part, this time it's a metal washer for one of the EK waterblocks.

After that, I found out that the 1/2"ID 3/4"OD fittings wouldn't fit properly on the RP-450X2 res, so I'm exchanging it for the newer revision, despite the fact that I don't like the look of it quite as much.

I got ahold of Performance-PCs, who forwarded my email to EK and Bitspower, and they should be able to replace the metal washer for the EK block, courtesy of Eddy at EK. Still waiting on an email back from Bitspower about the one I lost from their block.

On top of all that, I ran out of tubing, and dinged up a couple of the fittings pretty badly, even though I thought my crescent wrench was pretty well padded with that bandage tape.

I obviously need to buy a new one with a legit rubber coating. Any suggestions?