Guys just a pointer and I hate to sound 'harsh', but this isn't a general oveclocking and discussion thread. If you don't have an OC of 4.5GHz or over validated with 20+ loops of LinX, and instead you just have general discussion of GFLOPS and 2 and 4 loop runs of LinX posts, best to post somewhere suitable for general stuff like that like your motherboard thread etc. I don't feel it's appropriate to expect people (and Zalbard) to wade through that stuff in here - save posting here for when you have got your settings down and worked hard to get that 20 loop run done.
A question here or there I think is fine, but I just hope this thread stays specific and on task rather than drifting. Most threads like this get forgotten about and never updated, Zalbard does an awesome job and I think it's the spirit of this thread to stay specific about 4.5+/20+ loops.
EDIT - I dunno, reading over my post I seem like some whinging old guy. Im all for helping each other out and stuff, just, I dunno it sounded ok in my head..
Originally Posted by crossg
Spot on.
Bumped it a couple of notches and got a few 100 gfps. Tried with 5120 Mb of ram, 10240 Mb didn't seem to help with more ram and then tried 5120 Mb ram with 6C 12T. Too much heat to continue 96 deg on core 6and wouldn't get close to 100gfps.
@CryptiK. Nice.My 990 wants around 1.416 for 4.56 6C 12T but I only ran 4 loops of linx.
Just tried the same settings on my 990X and bumped the uncore to double the ram speed and set the VTT a little higher to 1.3375. No desire to push the Vtt any higher as I don't think the gflops will increase and it does pass LinX. I don't run this 24/7 just test and bench. I use 12 Gb of ram in day to day use but when benching I use 6Gb. Less heat. My ram isn't the greatest for Ocing so this was just to see if i could get 100 gflops and were drifting off topic here.
Reply With Quote
Bookmarks