***Official***Z68X/P67A-UD7 Club/Discussion/Info**

[chuchnit]

I can run 3d with more than 107 mhz bclk (finished 2k1 with 108 and 2k6 with 107.4 mhz) without problems. Settings are very stable - when I can get into windows, I can bench.

Unfortunately I have some problems performance-wise. I have to figure out what it is - maybe chuchnit's issue has something to do with it.

Interesting. What PCH volts are you using? I am still very new to this board so I have a lot of feeling out to do with this setup. I was benching 01 last night at 100.8 set in BIOS (cpuz show -.2 bclock from BIOS) and my efficiency was down in game tests. I stepped it down to 100.5 and my score popped. Tonight I'm going to try some lower multi's and see if I'm just hitting a mhz wall.

[MusicIsMyLife]

Interesting. What PCH volts are you using? I am still very new to this board so I have a lot of feeling out to do with this setup. I was benching 01 last night at 100.8 set in BIOS (cpuz show -.2 bclock from BIOS) and my efficiency was down in game tests. I stepped it down to 100.5 and my score popped. Tonight I'm going to try some lower multi's and see if I'm just hitting a mhz wall.

I voltages are nearly stock. But I set it manually.

VCore: 1.435 volts llc1
VTT: 1.050
System Agent: 0.935
PCH Core: 1.050
PLL: 1.780
DRAM: 1.600

Everything else is set on AUTO.

With these settings I can go past 107 mhz easy. When trying to hit 108 I had to slightly adjust VTT to 1.1, System Agent to 0.945 and PCH Core to 1.1. If running high multipliers I have to set PLL to 1.84 and adjust VCore (up to 1.60).