I'm stuck at 200bclk.
I can never fully stabilize at anything above.
Current settings:
4210MHz
Mult:21
BCLK: 200
PCI: 100
CPU Config: all disabled, except HT and ALL cores enabled.
vCore: 1.3750
vTT: 1.33750
CPU PLL: 1.2
vIOH: 1.20v
vICH: 1.16v
vDDR: 1.65625v
DDR: 2000MHz 3x4GB 9-9-9-25-110-1T

With the above settings I'm fully 100% LinX stable with both ALL mem and 8GB mem. Running 8GB results in 10C higher temps during LinX runs than ALL mem does.

If I even go up one mhz to 201BCLK, it seems no matter what I do, I can not get stability. Linx will stop on error after the 2nd loop almost every time.
*sigh*

I was able to boot at 25x180 with 1207 bios tho. That was not possible with any bios before for me.