Jump into the R3E thread
Also be really careful with voltages, Vtt 1.5v is scary stuff, so is 1.65v on water, you don't need anything like that for 4-4.5GHz and 32nm cpu's are very sensitive to it.
Try this though:
Cpu configurations: ALL OFF (exceto HT e ALL CORES) Turn TM on incase something happens and you need it
Cpu Voltage OCP: OFF
QPI, PLL Voltage OCP: OFF
CPU PLL: 1.30v Set this to default 1.80v and only change it later on once things are stable
VTT/QPI: 1.35v ~ 1.50v (Nada com sucesso) Keep this under 1.40v max, the lower the better! (to a point)
Vcore: 1.50 ~ 1.65v (Nada com sucesso) - way to much vcore, keep it sane. 1.375v (real) max for now
Clock testado: 4200mhz ~ 4812mhz (Nada com sucesso)
Uncore: 2800mhz ~ 4000mhz (Nada com sucesso) - use the lowest or second lowest setting
Cpu Ratio: 29 ~ 35x (Nada com sucesso) - Try 25-29x to start with.
Load line: Full Calibration - I use 50% LLC its better for your CPU
Mode: X-Power - try T Balanced + Power, works fine for most of us
PCI Express: 102 - why 102? Set to 100 to start with
Spread Spectrum / CPU e PCI: Disable
Hardware Prefetcher and Cache: Enable
Set your ram speed to around DDR3-1500 to 1700MHz and use loose timings to start with. Use 1.64XXX vdimm to start with.
Reply With Quote
Bookmarks