Quote Originally Posted by andressergio View Post
C-N im having boot loops and takes a lot of time to enter bios after i start setting CE1 and EIST (shold i use CE2 etc ? ) and put NORMAL and set dvid... my LOAD vcore is 1,392-1,404 and vid its 1,2550 but happens that sometimes its shows 1,37 so last time i put 0,0100 more and ended on 1,5, then when it showed again 1,2550 was low...so im kinda lost

i see that setting DVID also its very different with LLC1 doesnt drop so much

i will keep on trying laterz as i hate those reboots

cheers
Sergio
That's the same sort of issue I have with the UD5, if normal vcore would stay put I'm sure I could get it running all be it with a tad more voltage than needed. If you want to use it keep messing about but I have given up with mine its just not good & reliable enough imo.

Good to confirm its not just me with the extra voltage using normal/dvid & Level 1