SandyBridge 2D madness - let's tweak for the best 1m, 32m, pifast and wprime!

[3oh6]

Jody I assume your on phase still?

I'm at max 20C cpu full load.......6C quite often.

Dino your on H70 water normal ambients?

Cheapseats what temp are you running the cpu at or keeping it under?

nope, still on water. no point in insulating the board if it is 4 seconds slower than the M4E. i wanted to test on water first to ensure it wasn't cold
that was causing the memory clocking problems i had on the M4E.

under load the core running gets to 40C max.

as for sub timings, i too did one at a time and tested each. most don't show any gains, but tightening any of them didn't cause my time to slow.
this is something bigger than a single sub timing.

i was using a POS SSD and was thinking this morning as i got up if i should try a SATA. gonna also start messing with other BIOS's. but Brian is
right...this is retarded and not worth my time to be honest.

any chance you have a different rev of board Dinos? after the UD9 bullshyt, i don't rule anything out.

****edit - solved***
there it is. thanks for the images of the BIOS Dinos

it is the "No Execute Memory Protect"...needs to be disabled. flick of a switch