******Gigabyte GA-P67A-UD4 Discussion Thread******

[simonmaltby]

Thanks for this post dinos22.... I have had a go with your settings and my own issue remains.

I think my issue is different to others and I'm certain it must be a hardware fault. I have ordered another board which will be here tomorrow.

My issue is that any alteration to vcore will cause a bizarre result....
This is what I do, although I have tried many variations / bioses etc.

Clear CMOS for a nice fresh setup
Boot to Bios
Check settings (turbo and vcore) these show 1.188v vcore or 1.220 in the advanced voltage page (AUTO). Board reports Boot at 34 and Turbo at 35 - All as it should be.
Alter vcore (Tried all sorts but say 1.35v).
F10 and save - then re-boot
Comes back fine, but Vcore now reports as 0.98v and Board reports Boot at 34 and Turbo at 16???? WTF
If I then do F10 and save again... board will go into a power on and off cycle with no beeps or VGA

Just to add that if i leave Vcore on Auto and LLC to Enabled it works ok I can set turbo at 50 and boot into windows where vcore is reported as 1.38v
The chip will do 5.3+ on an asus P8P67 but needs 1.45 - 1.5v hence why i want to set the vcore manually.