Gigabyte GA-P67A-UD5 Discussion Thread

[scccm]

i lowered the cpupll a few notches more and found stability at even lower voltage .. but 1.7v caused a no post(and auto bios flash) for me

seems a little too good to be true. i needed 1.45v for a stable run at 5.0ghz now i only need 1.38v

I wonder what pll voltage your chip was getting by doing that....im going to take a guess that "Auto" sets it at 1.80, and Overvoltage sets it at 1.90, so 1.76+overvoltage=1.86? ...would be nice if there were a sensor....

ill try it disabled cpupll overvolt and manually set it to 1.86 . see if i get the same results