Can't stable "Elpida Hyper" With i7-2600K

[Lsdmeasap]

I just passed 32M at 5GHz DDR3-2133 8-8-8-24 88 1T
That is with the UD7 bios F7d, my DIMMS are in slots 2 & 4

2133 7-7-7 has never been good for me on my ES or this retail chip.....but 7-7-7 was fine at 1866 as you stated Ed

These DIMMs also run fine at 1866 6-6-6-18 60 1T on x58 with 1.7V....but they wouldn't even boot with my ES D1....still have not tried on my retail D2

So you use more system agent than what some have recommended as well eh? Clunk told me he noticed improvments at higher clocks with tight timings using 1.3-1.4 VCCSA, UD7 stops ate 1.305

So if this is a needed setting change for some clocks hopefully Gigabyte will increase the allowed amount on this.

in my thread i was running

1067MHz 7-7-7-21-1T 32M easy

but i needed 1.24QPI/VTT and 1.78vdimm, that was the key for me, system agent didnt do anything

http://www.xtremesystems.org/forums/...d.php?t=265130

i recommend using slots 2 and 4, it seems to be a bit better

It's too bad all CPU's wont take high QPI/Vtt, the one I have stops booting at 1.2, sometimes I can get 1.22 to post but not often.

I always use extreme on the performance enhance, do you think that holds me back? I know on X58 and P55 it was the most stable and provided the best bandwidth for sure!

Hey, would you mind passing this info along to the BIOS guys and see if they can address this in our BIOSes, or add the optional setting, I think it applies to us as well.
http://www.xtremesystems.org/forums/...d.php?t=265454

I'm about to try out SS on one of these setups, I know many say it doesn't clock well like that, but since release I have seen quite a few using phase with positive results.

Seen anyone on Dice or Ln2 with these yet?