Quote Originally Posted by Andreezy View Post
Yeah you still singing to the song of dead mans tune.
Bs in wiring..good for you I need some electrical done in my house
Maybe you can help...
Now back to rampage iii extreme...
Also when I enable xpower in digi power mode my qpi v droops all over the place
Do you know why that happens? When I leave it on tbalance its solid...
Can u help me solve or trace the source?

That's what I was trying to figure out.....
But u wanna focus in making yourself righteous or something..
So like I said before I could be wrong.....
So if you don't have any valid feedback, don't reply and look at your bs in wiring and assume I'm a moron.....its what I did. ;-)
The vdroop when Xpower is turned on is most likely caused by severely high temperatures in the mosfets providing power to the QPI bus.

Xpower allows significantly higher currents to be utilized for signal generation. That is for sure. If you sufficiently cool your QPI mosfets, the vdroop should be minimized. The stock cooler for R3E does NOT cool these mosfets. EK full coverage, koolance full coverage, and bitspower full coverage do cool these components.

Nobody is trying to be righteous. I want correct information, and I want to limit the spread of bad information. You obviously got the idea from somewhere, show where. That's all I've been asking. You got defensive when I asked you very nicely to prove what you were saying. You're not fooling anyone because everyone can see your comments. I've been polite the whole time. I even said 'please' when I asked for your proof.