Quote Originally Posted by Sanousie View Post
Fair enough, maybe its cause im on phase, its a different story with voltages and temps, think the evapo head needs a reseat.

I would of used the backup chip but i didnt have the 1504 on there, now i do, as i backed it up after flashing it.

I cant believe the difference in stability compared to the 1913, i need 1.525 qpi to run ram at 2000mhz now all i need is 1.475. I found lower timings are always better when compared to 2000mhz at 1.5qpi.

Just finding a balance between electicity use and performance :P, last electricity bill came to 500 plus dollars for just 3 people in a unit, lols, all my fault cause i need a air con to cool the room down when im gaming cause of the heat from the cascade and pc.

Anyone know if ther eis a proggy other than cpu tweaker which would allow me to change sub timings and cpu multiplier within windows? Turbo v is good, but its limited



www.photobucket.com go here, make a account, and than upload pic and copy url here , GL.
Ugh, electricity prices in NSW are crazy. They increased it what 20-30% under the guise of 'upgrading infrastructure' then the government re-appropriated the money and spent it on other things, then said they would raise prices again to cover the infrastructure. Appalling. Perhaps you should move to water, you can still have great temps (on your VGA's too) with much less noise and less power consumption.

Quote Originally Posted by Maxpayne View Post
CryptiK please post your bios setting,great bclk
Surprisingly straight forward. Main settings as follows:

Vcore: 1.1875 BIOS
LLC: Off
Vtt: 1.40000 BIOS
VPLL: standard (1.80v)
vIOH: 1.35 - 1.40v BIOS
vICH: standard (1.11v)
vPCIE (IOH & ICH): Both standard (1.50v)

PCIE: 108-115 MHz (115 works well)

CPU SKEW: Auto (100PS also works)
IOH SKEW: Auto (600PS also works)

Ram: 2:8 divider 1.55-1.60v (whatever your ram needs)

QPI DATA LINK RATE: SLOW MODE (this must be in slow mode when link rate is over 8000 MT/s, or my board wont post. I have verified this at various BCLKs bumping up QPI speed to next settings. As soon as its over 8000 it just flakes out. Seems the R3E's can handle this and can run up to ~8300 MT/s so they can hit 230 BCLK without using slow mode.

Quote Originally Posted by Sanousie View Post
This is with 2x5850 running stock, Increased clocks to 900core 1150mem only gained 400 points at 1024res

http://i1113.photobucket.com/albums/...usie/45g-1.jpg

This is my highest oc so far, im sure it can go more, this is prime stable by the way, i can boot into windows higher around 4.7-4.8 but its not stable.
Looking good, at low res you are more CPU limited than card limited. Try default res of 1280x1024 at least, or a real game demo bench at that res or higher and you should see a bigger difference.