Abit IP35 Pro - VMod needed

[Spacehead]

Sorry to revive an old old thread
Noob question:How do you guys do the vdroop mod provided by jonny bravo for IP35 Pro??
Attempted this and i have screwed up pretty badly
Two component had come out during the modding process and now i am stuck at 87 post code
So any solution to the issue i am facing?

Have you lost the components? They should be soldered back to the board or else the circuit is not functioning.

If they are resistors I could measure them if you give me a picture which shows the missing parts positions. I cant measure capacitors at the moment.

[OC4/3]

Have you lost the components? They should be soldered back to the board or else the circuit is not functioning.

If they are resistors I could measure them if you give me a picture which shows the missing parts positions. I cant measure capacitors at the moment.

Think i had lost the component
The component is as per Jonny Bravo Vdroop Mod Point(The two pieces marked with red dot)

[Spacehead]

Think i had lost the component
The component is as per Jonny Bravo Vdroop Mod Point(The two pieces marked with red dot)

I checked again and noticed that the resistor values are different in Abit IP35 and IP35-Pro. I have the IP35.