Gigabyte GA-P67A-UD5 Discussion Thread

[C-N]

last question.

v-droop on heavy load?

whats' under the center cooler?

std = quite a bit & kind of the same as most bords, seen .05v so switched to LL1 & voltage increases with load, cant get LL2 to work.

Dont know havent looked, it dont get hot so maybe nothing!!! BUT IT LOOKS GOOD LOL

.

[Andrea deluxe]

std = quite a bit & kind of the same as most bords, seen .05v so switched to LL1 & voltage increases with load, cant get LL2 to work.

Dont know havent looked, it dont get hot so maybe nothing!!! BUT IT LOOKS GOOD LOL

.

is possible to fit this:
http://www.xbitlabs.com/picture/?src...c_size_big.png

on UD5???

please measure the height of the chipset cooler and tell me yes.....

[C-N]

Oh just the usual. I would LOVE to see 3D01 and super pi ran on XP 32-bit!! Maybe some ram overclocking and telling how much volts the NB needs to run at high ram clocks. I am particularly interested if it needs "more than safe" volts to run 2ghz+ ram. Other than that I would just like to see the memory tab in CPUZ in the screens and whatever benches you feel like running.

I wont be using XP only 7 & 3D01 dont run worth benching in 7.

SPi runs 7.75s @ 4.85 & I reckon the 2600k with its extra L3 cache will be even better.

The board clocks RAM very well, I have just run DDR2150 CL9 & it makes 24K+ in everest @ about 37 ~ 37.5ns depending on how you tweak the RAM. I have the NB @ stock. I did put the mem tab in the last ss.

Gee ppl just hammers these chips 4.8ghz with a 2500k is just nice.

I belive budgetoverclocking just got extreme

Yeah me too

is possible to fit this:
http://www.xbitlabs.com/picture/?src...c_size_big.png

on UD5???

please measure the height of the chipset cooler and tell me yes.....

Ye should fit the heatsink is under 30mm tall so it will fit up down or left right. My heatsink covers the first 2 mem slots fitted up down but I only have low RAM modules so they fit fine.

.