My small Cosmos - LC by Tadzik

[tadzik1231]

And as for radiator cage: I had an impression that separate mesh panels are not flat and are fitted to aluminium frame. This is what I meant:

I've seen your build before - very nice - but personaly I prefer something more puristic. Coming back to the point "I'm using flat file sharp end protected with a soft fabric to press the mesh in". It's hard to explain even in my nativ language. First you need a properly cut piece of aluminium mesh, you put the mesh from inside into the cage which lay down on a floor/table with something soft below (bathroom towel is the best). You stabilized the mesh ( hand or adhesive tape) and press it spot by spot along edge of the hole using a flat file ( the end of file should be protected with a soft fabric). You repeat it several times. Dont't know if it's clear.