Originally Posted by facboy
Here they are, my current folding settings, stable, but still testing and trying out other combinations.
This is what I'm working on, but not folding stable yet...Code:Target CPU Frequency 4402MHz Target DRAM Frequency 2277MHz LN2 Mode: Disabled*** QPI Loadline Calibration: Enabled*** Sync Mode [Enabled] AI Overclock Tuner [Manual] OC From CPU level Up [Auto] 2D Performance Booster [Disabled] CPU Ratio Setting [31.0] CPU Turbo Power Limit [Disabled] >CPU Configuration---------------------------- CPU Ratio Setting [21.0] C1E Support [Enabled] Hardware Prefetcher [Enabled] Adjacent Cache Line Prefetcher [Enabled] MPS and ACPI MADT ordering [Modern] Intel(R) Virtualization Tech [Enabled] CPU TM Function [Disabled] Execute Disable Bit [Enabled] Intel(R) HT Technology [Enabled] Active Processor Cores [All] A20M [Disabled] Intel(R) SpeedStep(TM) Tech [Enabled] Performance/Watt select [Power] Intel(R) C-STATE Tech [Enabled] C State package limit setting [Auto] C1 Auto Demotion [Enabled] C3 Auto Demotion [Enabled] ---------------------------------------------- BCLK Frequency [142] PCIE Frequency [100] DRAM Frequency [2277] UCLK Frequency [3986] QPI Link Data Rate [6833] Memory Configuration Protect [Disabled] >DRAM Timing Control-------------------------- CAS# Latency 9 [9] RAS# to CAS# Delay 11 [11] RAS# PRE Time 9 [9] RAS# ACT Time 27 [27] RAS# to RAS# Delay 7 [Auto] REF Cycle Time 126 [Auto] WRITE Recovery Time 18 [Auto] READ to PRE Time 8 [Auto] FOUR ACT WIN Time 32 [Auto] Back-To-BackCAS# Delay 0 [Auto] Timing Mode 1N [1N] Round Trip Latency on CHA 58 [Auto] Round Trip Latency on CHB 60 [Auto] Round Trip Latency on CHC 61 [Auto] WRITE To READ Delay(DD) 6 [Auto] WRITE To READ Delay(DR) 6 [Auto] WRITE To READ Delay(SR) 21 [Auto] READ To WRITE Delay(DD) 10 [Auto] READ To WRITE Delay(DR) 10 [Auto] READ To WRITE Delay(SR) 10 [Auto] READ To READ Delay(DD) 7 [Auto] READ To READ Delay(DR) 6 [Auto] READ To READ Delay(SR) 4 [Auto] WRITE To WRITE Delay(DD) 7 [Auto] WRITE To WRITE Delay(DR) 7 [Auto] WRITE To WRITE Delay(SR) 4 [Auto] ---------------------------------------------- CPU Differential Amplitude [Auto] CPU Clock Skew [Auto] IOH Clock Skew [Auto] ------------ Extreme Engine Digi+ ------------ Digi+ PWR Mode [T-Balanced] PWR Volt. Control [Auto] Load-Line Calibration [Full] CPU Voltege OCP [Enabled] CPU PWM Frequency [Auto] Extreme OV [Ensabled]* Extreme OC [Auto] CPU Voltage 1.402 [1.40000] CPU PLL Voltage 1.204 [1.20575] QPI/DRAM Core Voltage 1.415 [1.42500] DRAM Bus Voltage 1.654 [Auto] >DRAM REF Voltages---------------------------- DRAM DATA REF Voltage on CHA [Auto] DRAM CTRL REF Voltage on CHA [Auto] DRAM DATA REF Voltage on CHB [Auto] DRAM CTRL REF Voltage on CHB [Auto] DRAM DATA REF Voltage on CHC [Auto] DRAM CTRL REF Voltage on CHC [Auto] ---------------------------------------------- IOH Voltage 1.151 [1.15275] IOH PCIE Voltage 1.508 [Auto] ICH Voltage 1.111 [Auto] ICH PCIE Voltage [Auto] *QPI Voltage OCP [Enabled] *IOH Voltage OCP [Enabled] *DRAM Voltage OCP [Enabled] *QPI PWM Frequency [Auto] *IOH PWM Frequency [Auto] *DRAM PWM Frequency [Auto] ---------- Spread Spectrum Control ----------- CPU Spread Spectrum [Disabled] DRAM Spread Spectrum [Disabled] ***on-board jumper dependant
Reply With Quote
Bookmarks