XS HWBot Team

[Don_Dan]

Ok - making some progress with the dominator 2kc7's
This is with MCH core at 1.48v and dramv at 1.78v.
cpu @ 4300, no oc on the vc, no Areca, x25-v as the boot and HDD target drive
Not done yet but doing much better!
Thanks for all the help guys!

Nice work!
Did you lose some FSB frequency, or can you still go up to 450MHz like in your previous result?
Any chance you can run 7-7-7-24 and tighten down the PL to 8 at those clocks? PL7 is probably too much to ask for from that poor little NB.

As much as the CPU can do - high FSB will increase memory bandwidth dramatically. Try around 510 x 8,5 with 3:5 memory divider, if the CPU is capable of such high FSB.

I doubt the CPU can do that kind of FSB speed, most of the other Celerons have even lower FSB walls, this one is quite good in fact.
It's worth a try of course, but I'm not very confident it's possible.

The 3.33 (3:5) divider is borked, it doesnt run at its rated speed and is really only a 3.00 (2:3) divider. The only real option for higher fsb is the 3.20B (5:8).

It's only bugged on the 400 strap, isn't it? However, running the 200 strap should be pretty hard on the board, so 5:8 is probably the best choice when using higher FSB speeds.

[Hoss331]

It's only bugged on the 400 strap, isn't it? However, running the 200 strap should be pretty hard on the board, so 5:8 is probably the best choice when using higher FSB speeds.

Yea supposedly its only the 400 strap 3:5 thats bugged but unfortunately they didnt include the 200 strap 3:5 on the ddr3 board.