As you can see this particular model does not come with a mosfet heatsink sadly. So i tried fitting my thermalright hr-09 mosfet heatsink on it but it wouldn't fit because it was just a tad too thick. It was in the way of the capacitors, 8pin power and the chokes. So i ground down the sides just enough to make it fit. However, now the stock mounting brackets would not fit either so i came up with a make shift mounting mechanism with some screws, washers and nuts.
A quick coat of paint
And assembled onto the board
A quick test to see if the chip unlocks...
Success!
Reply With Quote
Bookmarks