Another dead DDC 3.25 ?

[jayhall0315]

It means I had to remove the 4 screws from the bottom of the XSPC dual DDC reservoir in order to take the DDC 3.25 for examination (after it was clear it was not working correctly). When I did, obviously a little bit of water leaked out as well (take a look at the XSPC reservoirs at their site if you dont know what I am talking about)

I took it to the evaporation chamber simply to remove all water drops or vapor and to know that if there was a problem, it was not because of any moisture.

I might add again that the engineering geniuses who built this POS left four small holes for water to leak into from the top if it seeps past the o-ring.....brilliant. Perhaps they used to design o-ring seals for the booster rockets on the space shuttle before they acquired their present job.