Nope,that's just a quote from the hw-info's article(translated here):
We could bring AMD to make a statement about the performance: the Zacate APU should be appreciably faster than an Intel Core-based Pentium dual core, but no comparison was given to the coming Intel Sandy Bridge, as AMD has Llano, their second APU ready for that.
~~~~ http://www.chip-architect.org ~~~~ http://www.physics-quest.org ~~~~
Thats a not precise statement.They could mean overall performance, like combining cpu + igp performance.If they would get similar to core performance, it would mean that one bobcat core is pretty much equivalent to a athlon II core, which really is a stretch.We could hope, but in reality it is meant to bury atom, not core.We could bring AMD to make a statement about the performance: the Zacate APU should be appreciably faster than an Intel Core-based Pentium dual core, but no comparison was given to the coming Intel Sandy Bridge, as AMD has Llano, their second APU ready for that.
I hope im wrong tho, it would be fantastic.
And again, we know that liano on the cpu side, will be weak compared to sandy bridge, however, if you take into consideration overall gpu + cpu performance it makes sense as a competitor.
If bobcat core would be so powerfull, liano wouldnt make much sense, it would be better off with 4 bobcat cores(similar performance,lower size).
Last edited by RaV[666]; 09-04-2010 at 05:07 AM.
If Bobcat is even close to Core, Llano will make no sense
Im sure he talked CPU + GPU. Bobcat might as well be much faster than Atom (likely) with both the CPU + GPU, but Core? That seems a mighty stretch
i7 920@4.34 | Rampage II GENE | 6GB OCZ Reaper 1866 | 8800GT (zzz) | Corsair AX750 | Xonar Essence ST w/ 3x LME49720 | HiFiMAN EF2 Amplifier | Shure SRH840 | EK Supreme HF | Thermochill PA 120.3 | MCP355 | XSPC Reservoir | 3/8" ID Tubing
Phenom 9950BE @ 3400/2000 (CPU/NB) | Gigabyte MA790GP-DS4H | HD4850 | 4GB Corsair DHX @850 | Corsair TX650W | T.R.U.E Push-Pull
E2160 @3.06 | ASUS P5K-Pro | BFG 8800GT | 4GB G.Skill @ 1040 | 600W Tt PP
A64 3000+ @2.87 | DFI-NF4 | 7800 GTX | Patriot 1GB DDR @610 | 550W FSP
If it's faster than Atom? There is no "if",only how big the gap will be. And Core based Pentiums,IMO, is not Westmere+IGP but Penryn based ULV platform. This is in line with "90% of mainstream performance in half the die area" statement AMD made for Bobcat cores(not the whole Ontario APU). 90% of mainstream is 90% of Propus/Regor which pretty much equals Penryn 3M.
Last edited by informal; 09-04-2010 at 05:13 AM.
i7 920@4.34 | Rampage II GENE | 6GB OCZ Reaper 1866 | 8800GT (zzz) | Corsair AX750 | Xonar Essence ST w/ 3x LME49720 | HiFiMAN EF2 Amplifier | Shure SRH840 | EK Supreme HF | Thermochill PA 120.3 | MCP355 | XSPC Reservoir | 3/8" ID Tubing
Phenom 9950BE @ 3400/2000 (CPU/NB) | Gigabyte MA790GP-DS4H | HD4850 | 4GB Corsair DHX @850 | Corsair TX650W | T.R.U.E Push-Pull
E2160 @3.06 | ASUS P5K-Pro | BFG 8800GT | 4GB G.Skill @ 1040 | 600W Tt PP
A64 3000+ @2.87 | DFI-NF4 | 7800 GTX | Patriot 1GB DDR @610 | 550W FSP
You made to many assumption here. Based on what we know about bobcat architecture, it should be in range of athlon64 perf.
Lets see.
Bobcat:
2 decoders, 2 ALU+2 AGU (max 4 uops per cycle), 64-bit fpu (max up to 2 uops ).
Athlon64:
3 decoders, 3 ALU/AGU (max up to 6 uops per cycle) 64-bit fpu (max up to 3 uops per cycle).
Last edited by kl0012; 09-04-2010 at 05:34 AM.
Yes, but clearly they're not concerned in regards to Bobcat..they've laid out the various units within the uarch in the previous slides. Being fully synthesised and all, it's not like it means much anyway.
I do find it odd they've 'covered up' the cores in the full dieshot, but the shapes at least line up perfectly, but at the end of the day, for the purpose of the discussion, it's pretty clear the cores ~5mm2.
Regarding Llano.. it's clearly going to be considerably faster even IF the uarch has inferior perf/watt to Bobcat, as it's going to operate at much higher frequencies.
It's a totally different situation, being on GloFo's 32nm SOI process. Bobcat is Synthesised, designed to easily slot into a generic process like TMSC's, Llano is not, and seemingly Bulldozer is not either going by the "photoshopped' dieshots.
Last edited by mAJORD; 09-04-2010 at 05:44 AM.
I have doubted this before, cuz the core-part is looked like a cache.
But when I go over the preview of Ontario APU being held in June, found that the die-size on the wafer is nearly the same as today's clear die image, about 75mm^2.
So if this nowaday die-shot is Photoshoped, I guess it has used some cache blocks image to cover the core-logic. Although I seriously think whether there is any reason to do so.
![]()
Last edited by superrugal; 09-04-2010 at 06:15 AM.
And what do you think can tell the whole perf story? It has less pipelines, less execution resources, slower cache, only single channel memory and based on its size it has probably smaller ooo buffers, smaller uop reservation station and smaller register renaming files (relative to athlon64). You dont really expect that it will be faster then pentium (penryn/westhmere based) just because AMD said "90% of mainstream performance". Do you?
well duh. intel has no low speed SRAM cell for their 45nm HP node. just look at a shmoo of the atom.
in fact if you really want the truth, the bit-cell area is .3816um2 for the L2. this is to improve SER and performance. also the columns are very short to improve yields but at the cost of area.
I don't expect anything,I just quoted the hw-info article.And AMD stated the 90% of mainstream performance while mainstream in their pricelist is Regor(and Regor pretty much matches Penryn 3M).You can draw your own conclusions.
PS The Bobcat core is also new from the ground up design(not based on K8/10h),has more OoO capabilities than 10h and shares some functionality that is in BD.
Last edited by informal; 09-04-2010 at 07:32 AM.
I would not draw conclusions from anything AMD said. Otherwise we will end up with threads like this:
http://www.xtremesystems.org/forums/...arcelona+40%25
I prefer to wait and see. But till now nothing actually points that bobcat would be equal or faster then athlon64 (not to say penryn 3M).
Last edited by kl0012; 09-04-2010 at 08:06 AM.
We already have BOINC benchmark results for Bobcat A0,they are in line(+-5%) with Athlon II working at ~1.4-1.6Ghz.So this is not the same as Barcelona "claim"(which applied to some server workloads).
Last edited by informal; 09-04-2010 at 08:13 AM.
Bookmarks