Quote Originally Posted by BoxGods View Post
reservoir / rubber pad / mounting cage / rubber pad / load spreader / screws

Just like your typical engine mounts...not sure there is a path as the cage is in compression. If there was a pad on only one side or the other then yes I could see it. The pads are also over sized on both sides compared to a normal washer. The absolute would be the bungi style where a rubber pad/strap is mounted to the cage, then free spans a certain distance and the other end is hard mounted to the reservoir but that is pretty impractical in the space constraints and with both mounting surfaces parallel.

The big factor will be the composition of the rubber...too hard, not much dampening obviously, and too soft, not much compression. I agree that the delrin goes a long way towards making it a mute point anyway.

Will include pads in .5mm - 1mm - 2mm for custom configs.
Whoa man... from the abyss you return.

Is this one of yours?

Also, I may be misinterpreting the pictures, but it looks to me like there is a fastener which goes from case to delrin/rigid structure. If this is the case, then it's a damper, not an isolator. Again, I only see what's in the picture.