Rev 1.1 done - with mixed results.

The only upside was that I didn't break or flood anything

As for the flow with new SLI links - it actually dropped to 160l/h (from 200l/h)!
Simple conclusion - in this loop 14x90 bends doesn't matter significantly while adding MCR220 does.

But...I'm going to learn the lesson and plan for the next move

What's next? Some of you must be laughing now :applaud: yes I'm going to replace 2xD5 with 2xDDC and see how it's going to work in this mile long loop.

Tomorrow I'll post temps - it should be better still with the new rad even though the flow dropped a bit.

Now few quick shots to show the changes.