Quote Originally Posted by Grinder View Post
A set of screws are on their way to me, thanks to Michelle (very quick response).

I haven't installed my card yet, a Sapphire 5850. What is the current wisdom for the advanced install? i.e. remove ALL thermal pads, or just those for the VRM's? This is what is described in the current installation guide, but from the discussion here it sounds like all the pads need to be removed.

Also, do the screws need to be tightened completely to the standoffs?
1. All pads *except* those covering the memory modules should be removed.
2. You basically tighten all the way down to the standoffs but do it carefully. If you know that there is too much resistance I would stop. You do not want to crush any of the digital VRMs (very easy to crush them). This should not happen, but a cautionary note is worth while nonetheless.