ASUS Maximus Formula SE

[Mr. Scary]

Sorry for the delay cleatus, but i've been swamped at work as well as learning this asus board and bios! anyway, not sure how the template works but here's what's OCCT'd Stable at 3.9ghz, but i'll be damned if i can squeeze that sucker to 4.0ghz! i even thought about a hole right at 500fsb and tried 501&502,,,,no luck! anyway, again, this is just fartin' around, my dad's box comes over this weekend and i'm gonna drop his Q6600 in it and set up his raid 0 array as well. Also, i just got in the mail today the original Accessory box, brand new off of ebay to go with the bare board from my buddy! sweet bells and whistle's, just wish it was the SE, LMAO!!!!!

tx again for any sugg's in regards to the e8200 as well as the Q6600 comin' this weekend!

M$

ps-are any of these 'asus' programs that come on the original disc worth a crap?
i.e.,,,,ai booster, cpu level up, Qfan2, ai nap, ai gear3, ai suite, pc probe? if they are anything like the stuff MSI puts out with their mobo's forget it!
just curious as i haven't loaded squat on anything yet, also how about the bios flasher from asus? if not, why? & what then?

tx

BIOS: 1201
Extreme Tweaker
Ai Overclock Tuner : manual
OC From CPU Level Up : I DON’T HAVE THIS???
CPU Ratio Control : manual
- Ratio CMOS Setting : 8 (7or8 are my only choices)
FSB Frequency : 488
FSB Strap to North Bridge : 400
PCI-E Frequency: 111
DRAM Frequency: DDR2- set itself to 950(mem is reaper 1066mhz)
DRAM Command Rate : 2T
DRAM Timing Control: auto
CAS# Latency :
RAS# to CAS# Delay :
RAS# Precharge :
RAS# ActivateTime :
RAS# to RAS# Delay :
Row Refresh Cycle Time :
Write Recovery Time :
Read to Precharge Time :

Read to Write Delay (S/D) :
Write to Read Delay (S) :
Write to Read Delay (D) :
Read to Read Delay (S) :
Read to Read Delay (D) :
Write to Write Delay (S) :
Write to Write Delay (D) :
DRAM Static Read Control: enabled
Ai Clock Twister : strong
Transaction Booster : disabled
Relax: 0
CPU Voltage : 1.57
CPU PLL Voltage : 1.6
North Bridge Voltage : 1.55
DRAM Voltage : 2.10
FSB Termination Voltage : 1.52
South Bridge Voltage : 1.1
Loadline Calibration : enabled
CPU GTL Reference : auto
North Bridge GTL Reference : auto
DDR2 Channel A REF Voltage : ddr2_ref
DDR2 Channel B REF Voltage : ddr2_ref
DDR2 Controller REF Voltage : ddr2_ref
SB 1.5V Voltage : 1.5

NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU VOlt
Voltiminder LED :

CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled

Advanced CPU Configuration
CPU Ratio Control : manual
- Ratio CMOS Setting : 8
C1E Suppport : disabled
CPU TM Function : disabled
Vanderpool Technology : disabled
Execute Disable Bit : enabled
Max CPUID Value Limit : disabled

USB Configuration
USB Functions: Enabled
Legacy USB Support: Disabled